I do like my Stampin’ Up Tree Punch! So quick and easy to use. What’s your favourite craft tool?
Another 3 trees but no embossing this time instead I have used plenty of layers to add texture. It is still a relatively easy as long as you enjoy cutting.
Measurements:
- Base: Very Vanilla 5 1/2″ x 8 1/4 scored at 4 1/8″ or 14cm x 21cm scored at 10.5cm
- Layer 1: Copper Foil 5 3/8″ x 4″ or 13.6cm x 10.2cm
- Layer 2: Mossy Meadow 5 1/4″ x 3 7/8″ or 13.3cm x 9.8cm
- Layer 3: Copper Foil 4 1/8″ x 1 3/4″ or 10.5cm x 4.4cm ( part of this will be covered by the DSP)
- Layer 4: Brightly Gleaming DSP 5″ x 1 7/8″ or 12.7cm x 4.8cm
As I have cut my 12 x 12 into pieces already I cut this piece into 2 sections, the other section I will use another day for another project so keep your piece safe!
Quick and easy, just glue Layer 2 onto the layer 1 being careful to leave equal amounts of edging all the way around.
This can then be glued and adhered to the base layer.
Glue the Copper layer 3 and adhere onto layer on the upper section of the card again ensuring equal amounts of edging all the way around.
Using Dimensionals I attached the DSP.
For the Mossy meadow trees, I attached a Dimensional to the top of the tree and glue to the bottom, so that the tree is flat to the DSP but raised off the Copper foil.
For the last tree, I used one dimensional on the base and used a double layered dimensional for the top so that it stands out against the other two trees.
I used the co-ordinating sentiment and the little tree stamp for the inside of the card.
Thanks for reading Creative Fraggle and have a super stamping day!
Love Lynda x
If you are interested in buying any of the products used in today’s blog or would like to know the products used, click HERE.
